![]() Hw.em.eee_setting: 1 (per man this is the disabled value) Main references for settings were various forum posts and Are my expectations off? Or am I missing something?Įm0 is the WAN port, em1 (LAN) configured identically. But again, I am new to opnsense, and it has been quite a while since I've played with *nix firewalls / routers of any type. It seems very strange to me as well that the CPU utilization doesn't appear to change with IPS enabled. To me this doesn't seem like expected behavior and even though it's only an I3 it "should" be able to keep up (based on experience with commericial firewalls that have UTM). I've also tried with different rulesets (malware, ciarmy, botcc.portgroup) and get identical results. ![]() There also doesn't appear to be ANY change in CPU utilization / Memory consumption during the tests with IPS on or off. This made no difference what-so-ever.ĭisabling IPS, online speedtests immediately change to ~580Mbps down / ~290MBps up (fyi, this is a little better than the results I got with my old consumer router - which I would expect to be the case). I thought it might be related to the Intel NICs, as there are a lot of comments about them, so I went through all the standard "tunables" and made certain the em and dev.em.X.iflib settings werre the "recommended" for 1Gb Intel NICs. With IPS enabled and only using a single-ruleset (emerging web client, 859 rules) online speedtests show ~190Mbps down / ~290Mbps up. Opnsense initial install was 20.7, now at 21.1.2. ![]() Internet pipe is 300Mbps fiber-to-the-home. I have a Protectli FW6B with an Intel i3-7100U (2-core / HT, 2.4GHz) with 16GB of RAM and (6) Intel 82583V (I210) NICs. ![]() I'm new to opnsense, but have done a fair bit of research and looking through the forum threads as well. Sorry, I know there are a lof of threads related to this. ![]()
0 Comments
Leave a Reply. |